CPCCSF2003 – Cut and Bend Materials Using Oxy-LPG Equipment

by Lloyd | Dec 27, 2024

Current Status

Price

Closed

Get Started

This course is currently closed

CPCCSF2003 – Cut and Bend Materials Using Oxy-LPG Equipment

Course Content

Lesson Content

0% Complete 0/8 Steps

1.1 Review and clarify task to cut and bend materials using oxy-LPG equipment.

1.2 Review task specifications and check to make sure they are in accordance with legislation, regulations, and codes of practice.

1.3 Review work health and safety (WHS) requirements for the task in accordance with safety plans and policies.

1.4 Identify safety signage and barricade requirements.

1.5 Review environmental requirements for the task in accordance with environmental plans and legislative requirements.

1.6 Select plant, tools and equipment, check for serviceability and rectify or report any faults.

1.7 Calculate material quantity requirements.

1.8 Acquire materials for the task and locate them safely ready for use.

Lesson Content

0% Complete 0/6 Steps

2.1 Erect identified safety signage and barricades, and fit personal protective equipment (PPE)

2.2 Select appropriate fire extinguisher and locate it to be readily accessible prior to and during operations.

2.3 Attach regulators to oxy and acetylene bottles in accordance with manufacturers’ specifications and WHS regulations.

2.4 Purge lines to manufacturers’ specifications prior to lighting up.

2.5 Test equipment for leaks and either undertake corrective action or report faults.

2.6 Select appropriate pressures and cutting tips in accordance with material to be cut and manufacturers’ specifications.

Lesson Content

0% Complete 0/4 Steps

3.1 Mark material accurately and secure or clamp ready for cutting.

3.2 Light torch in accordance with manufacturer’s specifications.

3.3 Adjust setting of flame for cutting to manufacturers’ specifications.

3.4 Adopt correct cutting position to set-out mark during cutting.

Lesson Content

0% Complete 0/4 Steps

4.1 Mark material accurately and secure or clamp ready for bending.

4.2 Light torch in accordance with manufacturer’s specifications.

4.3 Apply heat to specified material and minimise weakening effects of the heating process.

4.4 Bend material to specification and cool appropriately.

Lesson Content

0% Complete 0/2 Steps

5.1 Switch off torch in accordance with manufacturers’ specifications.

5.2 Shut off gas supply in accordance with manufacturers’ specifications.

Lesson Content

0% Complete 0/2 Steps

6.1 Clear work area and dispose of, re-use or recycle materials in accordance with legislation, regulations, codes of practice and task requirements

6.2 Clean, check, maintain and store plant, tools, and equipment in accordance with manufacturers’ specifications and workplace requirements.